“Extra Pin U1-22 in Normal of part U1”, as shown in the figure below:
Cause analysis: the principle is that all modes of the components in the component library cannot match the introduced modes in PCB. The solution is either to complete or delete them until only one is left.
Delete solution:
1. Enter the library file. Duplicate a new component and rename it to “+Normal”.
2. Delete redundant modes:
3. Then the compiler will not have this error.
Cause analysis: the principle is that all modes of the components in the component library cannot match the introduced modes in PCB. The solution is either to complete or delete them until only one is left.
Delete solution:
1. Enter the library file. Duplicate a new component and rename it to “+Normal”.
2. Delete redundant modes:
3. Then the compiler will not have this error.
Read More:
- The element “extra pin The solution of “in normal of part” warning
- Unexpected token u in JSON at position 0
- [system]SyntaxError: Unexpected token u in JSON at position 0
- JS error: unexpected token u in JSON at position 0
- Solution of U disk content hidden by virus
- Ubuntu (16.04) creates a Windows boot U disk, using woeusb instead of DD
- [windows] U disk installed system, unable to format the selected partition [error: 0x8004242d]
- The Tomcat connector configured to listen on port 8080 failed to start. The port may already be in u
- Lenovo x3650 M5 installation esxi-5.5.0u3 failed to resolve circular relocation
- Package inputenc Error: Unicode character , (U+FFØC) (inputenc) not set up for use with L aTeX. See
- How to Fix TypeError: Cannot cast array data from dtype(‘float64‘) to dtype(‘＜U32‘)….
- U disk installation Linux system could not boot, / dev / root does not exist and the identified hard disk space is not available
- Solution of off grid pin in Ad
- The problem that the content extra data in the notification cannot be updated
- Proteus simulation duplicate part reference error
- Remote part of refspec is not a valid name in
- HALCON error #2036: could not find license file in operator set_ Part solution
- IntelliJ idea class is normal, but error is marked in red and cannot be found
- XML file should have root tag (extra content at the end of the document in file error)
- The problem that the normal of the model is no longer perpendicular to the surface after unequal scaling