Let’s see if the hard drive wire is connected. Two connecting wires, one big and one small


2. After entering through PE software, check whether there is a disk symbol
3. Press DEL to enter the motherboard 2113, go to Authentication → Secure Boot→ turn Enabled (as shown in Figure 52611) to Disabled (as shown in Figure 2) → F10 save and 4102 exit. (1 1653 must be saved and quit)
 
Figure 1
 

 
Figure 2

 
4. Press DEL to enter the motherboard and find Boot Options → Launch CSM → change Never to Always (as shown in Figure 3) → F10 save and exit.     
(Be sure to save and exit)
 
Figure 3

 
5. Press DEL to enter this time, adjust USB or CD to start and it will come out → F10 save and exit. (Be sure to save and exit)